Loosen and pull the corners
You need dust mask and gloves to protect themselves. Get those, before going to work. Use Abtafler to loosen up the carpet and to withdraw him in every corner.
-Pliers-Dust mask-Gloves-Knee pads-Carpet knifeMini crowbar-Measuring tape-Hammer-Vacuum cleaner-Plastic cupsHow to remove the carpeting
Cut the carpet into strips
To remove the carpet quickly and easily, cut it into wide strips. Use tape measure to determine the appropriate width. (Image 1) You then use a razor knife to cut it. (Image 2)
Pull each strip by loosening up him from the remaining carpet (fig. 1) you roll the Strip up and carry them out of the room (Figure 2)
Pull back and roll up the Strip
Remove the mat and the brackets
Once you have removed the carpet, it’s time to build the base, by viewing our photos. The most expensive step is to remove the staples. Make use of assistance to pull each clip from the underbody and put them in a disposable plastic cup.
Remove the base
Remove the bars
To pull the strips at the edges of the room, you access from small crowbar with a hammer until you did this get rid of the underbody. Use the crowbar to break up the strips and discard them. At the end, use vacuum cleaner to clean the subfloor.